Water Tanks With Outlet Connections; Corrective Action - Bosch EasyAquatak 100 Manual Original

14 | English
This enables the pressure washer to draw water up to 0.5 m
above the water level in the source. This may take up to 15
seconds.
Submerge the 3 m hose in water to displace the air. Connect
the 3 m supply hose to the pressure washer ensuring that
the inlet strainer remains submerged in the water source.
Run the pressure washer with the lance disconnected until a
steady flow of water appears from the high pressure hose.
Stop if this has not been achieved within 25 seconds and
check all the connections. Switch off and connect the lance
and nozzle to operate.
Troubleshooting
Problem Possible Cause
Motor refuses to start Plug not connected
Mains socket faulty
Fuse faulty / blown
Extension cable damaged
Motor protector has activated
Frozen
Motor stops Fuse faulty / blown
Wrong mains voltage
Motor protector has activated
Fuses blow Fuses incorrectly rated
Motor starts but no Nozzle partly blocked
pressure
Motor "sounds" but Insufficient power supply
fails to start
Voltage loss due to use of extension cable
Appliance not used for a long period of time
Problems with TSS (Total Stop System) device
Pressure pulsating Air in the inlet water supply hose/pump
Inadequate water supply
Water filter blocked
Water supply hoses squeezed
High pressure hose too long
Pressure too low, but Nozzle worn
steady
Start/stop valve worn
Note: Several types of
accessory will normally
deliver a lower pres-
sure
F 016 L81 745 | (23.11.2022)
It is important to ensure that all hose and coupling connec-
tions are of good quality, air tight and that all washers are in
good condition and correctly seated in place. Failure to do
so may affect the self priming performance.

Water Tanks with outlet connections

When connecting the pressure washer to a water tank with a
suitable tap outlet, first connect the supply hose (not
provided) to the tank outlet, open the tap to allow the water
to displace all the air in the hose and then connect to the
pressure washer.

Corrective Action

Connect plug
Use another socket
Replace fuse
Try without extension cable
Allow to cool for 15 minutes
Wait for pump/water supply hose/accessory to
thaw
Replace fuse
Check that mains voltage corresponds to specific-
ations on the model tag
Allow to cool for 15 minutes
Change to a mains supply higher than the pres-
sure washer amp consumption
Clean nozzle
Check that the voltage of the mains power supply
line is the same as that on the plate.
Check characteristics of extension cable
Contact your Bosch Service Centre
Contact your Bosch Service Centre
Allow pressure washer to run with open spray
handle and nozzle at low pressure until regular
working pressure is obtained
Check that the water supply corresponds to spe-
cifications. The minimum specification for the wa-
ter supply hose is 1/2" or 13 mm diameter
Clean water filter
Straighten out kinked water supply hoses
Remove high pressure extension hose. Retry (ex-
tension hose max. 7 m)
change the 360° Gun
Activate trigger five times in quick succession
Bosch Power Tools