Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
BLOWING FEATURE (See Figure 9.)
It can blow sawdust and other debris. Follow the steps below to use your vac as a blower.
1.
Locate blowing port of your wet/dry vac.
2.
Insert the larger end of hose into the blowing port of the vacuum.
3.
Attach extension wand ( not included ) to swivel end of hose.
4.
Turn vacuum on and you are ready to use your vacuum as a blower.
BLOWING PORT
VACUUMING TIPS
1.
The filter must always be in correct position at all times to avoid leaks and possible damage
to vac.
2.
When using your vac to pick up fine dust, it will be necessary for you to empty the
collection tank and clean the filter at more frequent intervals to maintain peak vac
performance.
3.
When the liquid in the collection tank reaches a predetermined level, the float mechanism
will rise automatically to cut off air-flow. You will know that the float has risen because
suction stops and the motor noise will become higher in pitch, due to increased motor
speed.When this happens, turn off the vac, remove the battery pack, and empty the
collection tank.
4.
After using the vac to pick up liquids, the filter must be dried to avoid possible mildew and
damage to the filter.
19
Fig. 10
Publicidad
Tabla de contenido
Solución de problemas
