General Maintenance; Filter Cleaning; Replacement Filter - GreenWorks BVU24211 Manual Del Propietário

MAINTENANCE

GENERAL MAINTENANCE

Before each use, inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from
various types of commercial solvents and may be damaged by their use. Use clean cloths to
remove dirt, dust, lubricant, grease, etc.
Always store the machine clean and in a dry enclosure with the battery charged.

FILTER CLEANING

Your filter should be cleaned often to maintain peak vac performance. Allow the filter to dry
before storing or picking up debris.
IMPORTANT: After cleaning, check the cartridge filter for tears or small holes. Do not use a
cartridge filter with holes or tears in it. Even a small hole can allow dust to come out of your vac.
Replace it immediately.
CLEANING A DRY FILTER
1. Some removal of dry debris can be accomplished without removing the filter from the vac.
Slap your hand on top of the lid while the vac is turned off.
2. For best cleaning results due to accumulated dust, clean the filter in an open area.
Cleaning SHOULD be done outdoors and not in the living quarters.
3. After filter removal from vac, remove the dry debris by gently tapping filter against the
inside wall of your dust collection tank. The debris will loosen and fall.
4. For thorough cleaning of dry filter with fine dust (no debris), run water through it as
described under "Cleaning A Wet Filter"
CLEANING A WET FILTER
After filter is removed, run water through the filter from a hose or spigot. Take care that water
pressure from the hose is not strong enough to damage filter.

REPLACEMENT FILTER

ModeL #BVU24211 that fits at COSTCO or call customer service for information on compatible
filters.
.
20