brondell SWASH DR801 Manual Del Propietário página 20

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATING THE SWASH
Special Mode Operations
Activating / Deactivating Silent Mode
1. To activate Silent Mode, press and hold the
" – " Water Pressure/Dry Temp button for
four seconds. A beep will sound to indicate
that Silent Mode has been activated.
2. To deactivate Silent Mode, press and
hold the " – " Water Pressure/Dry Temp
button for four seconds. Two beeps will
sound to indicate that Silent Mode has
been deactivated.
Activating / Deactivating Nightlight
The Nightlight is activated at the factory
by default.
1. To deactivate the Nightlight, press and hold
"+" for four seconds. This function cannot be
performed while sitting on the seat.
2. To activate the Nightlight, press and hold "+"
for four seconds. This function cannot be
performed while sitting on the seat.
Automatic Deodorizer
Your new Swash comes with an Automatic
Deodorizer, which turns on when the Seat
Sensor is engaged. The deodorizer will
continue to run for one minute after the seat
has been vacated.
To cancel the automatic deodorizing function,
press the Stop and Eco Mode buttons at the
same time and hold for four seconds.
18
Sleep Mode
In Sleep Mode, the Swash essentially
powers down. The Nightlight and the side arm
lights, the seat heater and the water heater will
turn off.
1. To activate Sleep Mode, press and hold the
Stop button for four seconds. The unit will
power down.
2. To awaken the Swash from Sleep Mode,
press the Stop, Front, or Strong button.
Factory Default Reset
It is possible to reset the Swash to Factory
Default settings.
To reset the Factory Default settings, press
and hold the Stop button for ten seconds.
A beep will sound at two seconds indicating
the beginning of the reset process and another
beep will sound at four seconds indicating the
reset is activated.
Automatic Tank Draining
1. To prevent stagnation, water in the warm
water storage tank can be set to drain and
refill itself if the seat hasn't been used in
48 hours.
2. To program this feature, press "Stop" and
"Water Temp." at the same time and hold
buttons for four seconds.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido