Installation; Wiring Configuration - Kicker KMXL65 Manual Del Propietário

Wiring Configuration

We recommend using 16 gauge (or larger) wire. The
KMXL Speakers are rated at 4 ohms and work with
any source unit or amplifier designed to operate at
a 4 ohm load. Make sure your source unit or
amplifier is rated for 4 ohm operation. Carefully
run the speaker wire in a location that is clear of
standing water and moving components of the boat.
At least two amplifier channels are needed for stereo
operation
1. Connect the KMXL speaker plug to the KMXL
crossover.
2. Connect the KMXL crossover speaker leads to the
speaker output terminals of your amplifier.
a. CLEAR BLUE WIRE - POSITIVE (+)
b. CLEAR BLACK WIRE - NEGATIVE (-)
Pro Tip: You're a KICKER KXM amplifier and a
few cables away from a full system upgrade that
will dominate any factory system! KICKER line of
amplifiers make it easy to upgrade to solid bass with
your existing or stock source unit. Also, ask your
dealer about KICKER Subwoofer upgrades.
English

Installation

5