Operation Instruction; Parameter Setting - D Devices D ENDO ROTATORY Manual De Instrucciones

4 Operation instruction

4.1 Working environment parameters
4.1.1 Environment temperature: +5°C ~ +40°C
4.1.2 Relative humidity: 30% ~ 75%
4.1.3 Atmospheric pressure: 70kPa ~ 106kPa
4.2 Starting and stopping of motor handpiece
a) Under the power off state of motor handpiece, press Main but-
ton,and then the motor handpiece will enter Standby interface. The
interface displays are as follow:
Standby interface
b) Under Standby interface, press Main button, and then the motor
handpiece will enter Working interface. The interface displays are
as follow:
Working interface
Press the Main button again, and then the motor handpiece backs
to Standby interface.
c) Hold down the Setting button "P", then press Main button to turn
off motor handpiece. In the standby interface without any key
down of the motor handle.
4.3 Selecting customized program sequence number
The motor handpiece has 10 memory programs(M0-M9) and 5
preset programs, press Adjusting button "+"/"-" to change customized
program sequence number during standby state.
M0-M9 is a memory program for canal shaping and measurement,
every memory program has its own parameters such as Operation
mode, speed and torque, all these parameters can be changed.

4.4 Parameter setting

11