Replace The Sensor Strip & The Battery - Tena SmartCare Change Indicator Instrucciones De Uso

Replace the sensor strip & the battery
Sensor strip replacement
The sensor strip is designed to withstand up to 12 weeks of continuous use. Sometimes,
however, the hooks on the back of the sensor strip can become covered with fibres or lint.
This prevents the hooks from attaching to the incontinence product. If the fibres or lint
cannot be removed, the sensor strip should be replaced. The sensor strip should also be
replaced if it is physically damaged in any way, if it becomes soiled with faeces and can not
be cleaned sufficiently. For cleaning advice, see page 22 of this guide.
Press
1
Battery replacement
If the LED light starts to blink, either the battery needs to be replaced or the transmitter is not
properly attached to the sensor strip. The CR2032 battery will last for up to 12 weeks. However,
the battery can be replaced whenever needed.
Press to
1
release
CHECK
If you have difficulty removing the battery, first press the locking tab,
then tap the transmitter in your hand until the battery falls out.
The transmitter is designed to withstand attachment and removal from
a sensor strip four times per year over two years. With more frequent
attachments/ removals, the system may not work as intended.
A pen or similar
can also be used
Remove the
2
battery
Remove the
2
transmitter
en
21