Bit Installation; Led Indicators - sunjoe 24V-AGR100 Manual Del Operador

Assembly
m
WARNING!
Accidental starting may result in serious
personal injury; always remove the battery pack from the tool
before assembly.

Bit Installation

1. Turn the auger body upside down.
2. Insert the auger bit onto the chuck, then slide the locking
pin through both the bit and the chuck (Fig. 2).
Fig. 2
Auger bit
Locking pin
3. Flip the wire latch over the locking pin to secure it in place
(Fig. 3).
Fig. 3
Wire latch
Operation
m
WARNING!
information regarding underground utilities before using this
tool. To reduce the risk of explosion, never use the auger near
any buried gas lines, water lines or pipes. Contact with or use
near buried water or gas lines may result in rupturing of water
lines or detonation of gas lines, which may lead to serious
injury or death.

LED Indicators

Mode
Powered On
In the event that the auger detects kickback or overloading of
the motor, the tool will automatically shut off to prevent bodily
injury or damage to the tool.
Remove the battery, and if necessary, allow the motor to cool
before resuming operation.
Chuck
Issue
Overload
Detected
Digging
1. Slide the battery into the battery compartment (Fig. 4).
Fig. 4
7
Contact your local utility provider for
LED Indicator
Green
LED Indicator
Red
Battery
compartment
Battery