What's In The Box - Anker 760 Manual Del Usuario

What's in the Box

Anker 760 Portable Power Station
Expansion Battery (2048Wh)
The expansion battery cannot be used alone. It must be connected to the power station for charging and
discharging.
Overview
1
On/Off Button
Long-press for 2 seconds to turn the expansion battery on and off.
LED Light-Wheel
The LED light-wheel shows the remaining battery by pressing the button for 1 second. The indicators will
flash in sequence white when recharging.
Expansion Battery Port
Connect the expansion battery to the power station via this port.
How Should You Recharge the Expansion Battery ?
1. Connect the expansion battery to the power station with the included battery-to-host cable to activate before
using for the first time.
2. Recharge your portable power station via AC input or DC input.
3. The connection is successful when the expansion battery icon appears on the power station's LCD screen and
you will hear a beep.
4. The expansion battery will be charged after the power station is fully charged.
01 EN
Battery-to-Host Cable User Manual
2
3
1
How Should You Use the Expansion Battery?
How to use the cable:
1. To connect, align the cable with the Anker logo in the center and insert it directly.
2. To disconnect, push the knob in the center of the cable and turn it 12.5 degrees counterclockwise before pulling it out.
1. Connect the expansion battery to the power station with the included battery-to-host cable.
2. The expansion battery icon will appear on the power station's screen and you will hear a beep when it is
successfully connected. If not, you will have to reconnect both devices as there may be a poor connection.
3. The expansion battery will charge your devices first until its battery runs out. The power station will then
continue charging your devices automatically.
4. If you need to disconnect or separate the expansion battery from the power station when they are in use,
press the on/off button for 2 seconds to turn the battery off to avoid a short circuit. To disconnect, push the
knob in the center of the cable and turn it 12.5 degrees counterclockwise before pulling it out.
2
EN 02