Safety Instructions - Würth HRS 3 Traducción Del Manual De Instrucciones De Servicio Original

Format of safety warnings
Type and source of the danger!
 Consequences of non-compli-
ance.
¾ Danger prevention measure.
Self and personnel protection
Persons less than 18 years old must not use the
■
device. Excepted from this are young persons
of 16 and over who are working under
supervision within the scope of their vocational
training.
Always remain alert and take the utmost care
■
when working.
Always wear suitable personal protective
■
equipment (suitable safety glasses, suitable
protective gloves).
Wear a special respiratory filter/mask.
■
Wear special clothing to protect you body
■
from contact with toxic vapours, solvents or the
products being processed.
 Poisoning can occur with some paints contain-
ing organic solvents due to the toxic vapours
which they give off.
¾ Always read the technical data sheets for the
products to be used before using them.
¾ Wearing personal protective equipment
reduces the risk of injury.
Never point the device towards any part of
■
your body, towards yourself or towards other
persons.
Safety in the workplace
When selecting and using the product to be
■
used, check by consulting the appropriate
safety data sheet, that it is compatible with
the area of work and the individual protective
equipment items.
Always earth paint spraying systems correctly.
■
Keep the device out of the reach of children
■
and never leave it unattended.
Disconnect the compressed air supply before
■
carrying out any work on the device, during
work breaks and when the device is not in use.
12

Safety instructions

DANGER!
Fire or explosion hazard
Do not use solvents and/or halogenated hy-
■
drocarbon-based detergents (ethyl trichloride,
methyl chloride, etc.).
 Such products could cause corrosion to
galvanised parts that may result in explosive
chemical reactions.
Do not use inflammable liquids.
■
Avoid naked flames and sparks.
■
Never exceed the maximum working pressure
■
of 8 bar!
Use the device only in well-ventilated rooms.
■
Do not use the device in potentially explosive
■
areas, as defined in the Atex Directive 94/9/EC.
Special safety warnings
Before starting work, check for trouble-free
■
operation, completeness and the serviceability
of the device.
Do not use a faulty device.
■
Do not use the device if its integrity may have
■
been impaired as a result of a collision or
fall. This applies in particular to parts subject
to continuous loads, to adjustable parts or to
pressurised parts.
 It is quite possible that defects such as frac-
tures, cracks or similar phenomena may not be
directly recognisable.
¾ In this case do not use the device and inspect
and test it before using again. If in doubt,
contact your local dealer before using the
device again.