GRE HIMPRN 21 Manual De Montaje página 4

installation instructions
Preparation
#2
of the site.
Installation site
Our pools are designed to be installed directly on the
ground and for outdoor family use. The ground must be
firm, smooth, and perfectly flat.
Do not forget: 1000 l. = 1 m
= 1000 Kgs.
3
Recommendations for choosing the best
location for your pool
→ Choose a place where you will have to dig as little as
possible to level the ground.
→ An area where in the event of rain, flooding will not occur.
→ Where there are no underground connections (water, gas,
electricity, ...).
→ Do not install under power lines.
→ Protected from the wind and free from trees since the
pollen and leaves can make the pool water dirty.
→ A sunny area, where there is most sun in the morning.
→ Near an electricity outlet, water outlet, and drainage.
1
Mark the installation area:
Once the location area is chosen (which have
to be perfectly levelled), we'll proceed at the
marking.
4
2
Levelling:
When levelling the ground, always remove
material from the top of the slope rather
than filling in the bottom: this will ensure
greater ground stability and firmness. Always
remove all grass, roots, stones, etc. Levelling
is extremely important: devoting the neces-
sary time and effort to ensuring that your
pool sits properly on the ground will avoid
problems later.
FLOUR
3,5 m
minimum
3
Finishing:
On the cleaned and levelled ground, spread
a light coat of sieved sand (max. 1cm).
Water and compact it (with a garden roller).
Check that is well levelled.
Do not use the sand to level the ground. The
finishing has to be perfect.
Necessary pools (not included)