Installing The Led Assembly And Glass - Hinkley 66 CONCUR Manual De Instrucciones

INSTALLING THE LED ASSEMBLY AND GLASS SHADE
CAUTION: To reduce the risk of electrical shock, disconnect the
electrical supply circuit to the fan before installing the light kit.
Remove one screw from the light kit pan and loosen, but do
1
not remove the other two screws. Connect the wires from
the light kit fitter assembly to the wires from the fan motor
assembly by connecting the molded adaptor plugs together.
Carefully tuck all wires and splices into the switch cap.
Push the light kit assembly up so that the two loosened screw
2
heads fit into the keyhole slots. Turn the light kit assembly
clockwise, tighten the screws. Reinstall the screw that was
removed in step 1 and tighten firmly.
Place the glass shade into the light kit pan, aligning the three
3
flat areas on the top of the glass shade with the three raised
dimples in the light kit pan. Turn the glass shade clockwise
until it stops.
Figure 1
Figure 2
©2022 Hinkley Lighting, Inc. hinkley.com
LK Pan
LED Assembly
Glass Shade
11