Auto Start; Dimensions - Cole-Parmer OS-200D-C-SYS Manual Del Usuario

Auto Start

This stirrer includes an optional Auto Start feature. When set, the stirrer will resume
mixing after a power failure, when power has been removed by control equipment
(i.e., PLC) or when the power has been cut (i.e., stirrer unplugged). When power
is restored, the stirrer will automatically ramp up to the last set speed and resume
mixing. The stirrer ships from the factory with Auto Start disabled.
To set the Auto Start feature first ensure stirrer is powered off. Press and hold the
Increase Button then press the Power Button. A dot will illuminate in the bottom
right corner of the LED display to indicate the Auto Start feature is active. Press
power button to turn the stirrer on and begin mixing.
To disable the Auto Start first ensure stirrer is powered off. Press and hold the
Decrease Button then press the Power Button. The dot on the LED display will go
out to indicate the feature has been disabled.

Dimensions

53mm
[2.1 in]
141mm
[5.6 in]
j
Four-digit LED display

Button - Power on/off

Button - Increase rpm

Button - Decrease rpm
102mm
[4.0 in]
6
157mm
[6.2 in]
96mm
[3.8 in]
100mm
[3.9 in]

Collet

Housing

Clamp opening

Clamp knob