Programming Mode; Restore Factory Settings - WUBEN X2 Manual Del Usuario

Lock/Unlock: In the power-off state, press the switch four times, the front light flashes
6
three times, indicating that the lock is locked, press the switch, the indicator light will
flash three times, and press the switch four times again, the energy-saving gear will light
up, indicating that the lock is released.

Programming mode

Before entering the programming mode, firstly determine which of the brightness gears
you want to customize, click to turn on the product, long press to adjust the product to the
gear you want to customize, quickly double-click and press the switch for the second click
without letting go.The brightness can be changed from small to large in the lumen range of
the corresponding gear (when reaching the pole of the interval, the light flashes once and
continues to cycle from large to small),when the set brightness is reached, release the
switch to remember the current brightness. So far, the brightness of this gear is
successfully set as the current brightness.

Restore Factory Settings

In the locked state, click the switch -- with an interval of 0.5 seconds -- double click the
switch -- with an interval of 0.5 seconds -- triple click the switch, and the flashlight factory
setting minimum light is on, indicating that the switch lock is released and the factory
default brightness is restored.
Mode
Low
Med
High
- 07 -
Adjustment interval
5-100 lumens
100-400 lumens
400-800 lumens