Grounding Instructions - Uline SANITAIRE H-10152 Manual De Instrucciones

WARNING! Improper connection of the
equipment-grounding conductor can result
in a risk of electrical shock. Check with a
qualified electrician or service person if you
aren't sure if the outlet is properly grounded.
Do not modify the plug. If it will not fit the
outlet, have a proper outlet installed by a
qualified electrician. This vacuum is designed
for use on a nominal 120-volt circuit and has
a grounding attachment plug that looks like
the plug in the drawing at right. Ensure the
appliance is connected to an outlet having
the same configuration as the plug. No plug
adapter should be used with this vacuum.
CAUTION! Assemble vacuum fully before using.
1. Slide upper handle and lower handle together
so handle bolt holes are positioned as shown in
Figure 1. Insert a two-part bolt in center of handle
and tighten. Hold assembled handle so handle
curves away from vacuum. Place lower handle into
handle socket at rear of vacuum. Align holes. Insert
two-part bolt and tighten using Phillips screwdriver.
(See Figure 1)
Figure 1
PAGE 2 OF 21
SAFETY CONTINUED
ASSEMBLY
Toward rear
of vacuum

GROUNDING INSTRUCTIONS

This vacuum must be connected to a grounded
wiring system. If it should malfunction or break down,
grounding provides a safe path of least resistance for
electrical current, reducing the risk of electrical shock.
NOTE: The cord for this vacuum
has an equipment-grounding
conductor and a grounding
plug. It must only be plugged
into an outlet that is properly
installed and grounded in
accordance with all local
codes and ordinances.
2. Pull the spring on the
electrical cord upward
toward the top of the handle.
Insert the lower half of the
spring into the upper cord
hook. Snap the hook into the
upper handle. (See Figure 2)
3. Insert the power cord into
the lower cord hook. Snap
into lower handle. Pull on
the cord to tighten but leave
enough slack near the base
so the cord is not strained
when the handle is lowered.
(See Figure 3)
Figure 2
Figure 3
1022 IH-10152