Bestway 58748 Manual Del Propietário página 9

Ocultar thumbs Ver también para 58748:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
CLEANING
Improper cleaning can result in damage to the device.
Cleaning the heat pump
• Do cut off the power supply before the cleaning process
• Do not use any aggressive cleaning agents
• Do not use any sharp or metal objects such as knives, hard putty knives or the like
• Do not use any cleaning brushes
• Do not use a high-pressure cleaner
• Clean the housing and ventilation grill with a slightly damp cloth carefully
• Dry off the heat pump with a dry cloth
SERVICE
Malfunctions
LED display off.
Pool Heater is not
LED display is on, and it
running
shows the water
temperature
1. LED displays on and it
Pool heating effect
2. The air from the blower
Water on the floor when
Water leakage
the Pool Heater doesn't
work.
WIRE COLOR CODE
BL
WH
BLUE
WHITE
BR
RD
BROWN
RED
GN
BK
GREEN
BLACK
Y
GR
YELLOW
GRAY
WFS
Water flow switch
Inlet Temp.
Inlet water temperature sensor
Amb. Temp.
Ambient temperature sensor
Coil Temp
Coil temperature sensor
MF
Motor Fan
COMP
Compressor
Observing
shows water temperature,
no error code displays.
is not cold.
MF
BL
Y/GN
GR
RD
Reason
No power supply.
1. Water temperature is
reaching the setting value.
2. The pool heater just
started.
1. Poor ventilation at the
installation site.
2. The heating system fails
and the fan blades does
not operate.
Water leakage.
Y/GN
WH
Reactor
WFS
BK
GN
BL
Amb. Temp.
C
R
WH
COMP
Coil Temp.
S
BK
Inlet Temp.
RD
Y/GN
9
Solution
Check if there is a power in the wall socket
where the Pool heater is connected.
1. Verify water temperature setting.
2. The Pool Heater has a built-in, 3-minute
start-up delay to protect the circuitry and
avoid excessive contact wear.
1. Check the location of heat pump unit and
eliminate all obstacles to make good air
ventilation.
2. For assistance, please visit the support section
of our website www.bestwaycorp.com.
1. Check the connection with the hoses untight,
loosen and place the gasket in position.
2. For assistance, please visit the support section
of our website www.bestwaycorp.com.
BR
BL
XT1
N
L
BK
BL
RD
N
L
RD
OUT3
OUT2
OUT1
BK
WFS
T1
T2
T3

Publicidad

Tabla de contenido
loading

Tabla de contenido