Sauder 427652 Instrucciones De Montaje página 12

Step 7 Step
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the RAIL SUPPORTS (J). Use four 1/2" FLAT HEAD SCREWS (19) through the
holes shown in the enlarged diagram.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to find the other hole that lines up with the hole in the END. Turn a SCREW into
this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
1
Push the black lever in and pull the SLIDE from the RAIL.
Open end
K
Page 12
2
Open end
1
J
L
www.sauder.com/service
1
1/2" FLAT HEAD SCREW
(4 used in this step)
1
Open end
J
19
427652