Tuning Procedure - Korg Pitchblack X Manual Del Usuario

Do not connect an AC adapter to the DC 9V OUT jack. Doing so may cause
a malfunction.
When the unit is operating on battery power, power is not supplied to the
DC 9V OUT jack.

Tuning procedure

1. Press the TUNER ON/OFF switch to activate the tuner.
The Tuning LED meter or the note name display lights up.
The signal from the INPUT jack will not be output from the BYPASS jack.
Tip: The TUNER ON/OFF switch only functions if an instrument is connected
to the INPUT jack.
2. If necessary, set the reference pitch and the display mode. (page 6
"Reference pitch settings", page 7 "Display mode settings")
3. Play a single note on your instrument and tune it so that the desired note
appears in the note name display.
The note name closest to the entered note appears in the note name display.
4. Tune your instrument using the tuning LED meter.
The method for indicating whether your instrument is in tune, sharp or flat
depends on which display mode you choose (page 7 "Display mode
settings").
5. After you finish tuning your instrument, press the TUNER ON/OFF switch to
turn the tuner off.
The Tuning LED meter or the note name display goes dark. The signal from the
INPUT jack is outputted to the BYPASS jack.
Tip: When you press the TUNER ON/OFF switch to turn off the tuner, the
reference pitch, display mode and bright mode settings are stored in
memory. These settings are preserved even if you remove the battery or
unplug the AC adapter.
Tip: To reset the settings to the factory defaults (reference pitch = 440 Hz,
display mode = regular, bright mode = brighter), hold down the CALIB
button and press the TUNER ON/OFF switch when you turn on the
tuner.
5