Anker Nebula Capsule 3 Laser Manual Del Usuario página 22

[Bluetooth Speaker
Mode]
[Advanced Settings]
Enable Bluetooth speaker mode.
[Projector Mode]: Select a way of placing the
projector.
• [Auto]: Automatically detects whether the
projector is inverted. Automatically switch
between these options.
• [Front]: The device is located in front of the
projection surface.
• [Front Ceiling]: The device is hanging from the
ceiling in an upside-down position. The image is
rotated by 180 degrees.
• [Rear]: The device is located behind the
projection surface.
• [Rear Ceiling]: The device is hanging from the
ceiling in an upside-down position behind the
projection surface. The image is rotated by 180
degrees and horizontally mirrored.
[Motion Settings]: Set a sensitivity level for the
G-sensor to trigger autofocus and auto keystone
correction.
[Keystone Calibration]: Recalibrate the projector
if keystone correction doesn't work properly.
[Smart Solutions]: Turn on / off auto-alerts
when the projector detects an issue.
• [Projection Angle Alert]: Shows an alert when
the maximum projection angle is reached.
• [Slow Charging Alert]: Shows an alert when
the power supply is insufficient.
• [Fine Tuning Alert]: Shows a prompt to access
fine-tuning after auto keystone correction.
EN
20