Function Introduction; Trademarks - RugGear RG750 Manual De Instrucciones

Phone status
In intercom mode
In charging mode
Non-intercom & charging mode

10. FUNCTION INTRODUCTION

10.1 Knob instructions
The knob can be rotated at any time, including clockwise or counterclockwise rotation.
It can be used to switch between different intercom groups conveniently, and it can support the voice broadcast
function.
(Note : Whether or not voice broadcast is supported depends on the PTT software);
10.2 Multifunctional Alarm (LWP)
Multifunctional alarm refers to the feature that detects the mobile phone status during motion and rest and
automatically notifies the emergency contact via phone call/SMS.
1. Default password: 1122.
2. After opening the application for the first time, you need to set a default phone number for the alarm.
3. If the mobile phone uses two SIM cards, you need to set a default phone number for dialling/SMS.
4. Any aborted operation will cause the application process to be interrupted and it needs to [close/open] the
application again in order to reset the alarm process.
5. The alarm will not be triggered when the mobile phone is connected to a USB charger.
Alarm trigger mode:
• One-button Alarm:
Click the SOS key to directly trigger the alarm process.
• Low Battery Alarm:
An alarm is triggered when the mobile phone's battery drops below 20%.
• Motion Alarm:
Vertical tilt 45°:
An alarm is triggered when the angle between the mobile phone and the vertical direction is greater than 45°.
Drop:
An alarm is triggered when the mobile phone is dropped.
Not moving:
An alarm is triggered when the mobile phone does not move for a certain period of time.
• Alarm Process:
Trigger alarm – Pre-alarm – Call the alarm phone number – Call the other contact – ...... – (sending an SMS link
with coordinates to the contact).
10.3 PTT/customize keys:
Your phone supports custom buttons, so you can use them to use quick applications.
The main function of the custom button is to quickly open the application you specify.
"PTT" in the list means: Long press the custom key to enable software talkback.
11. RECYCLING
The crossed-out wheeled-bin symbol on your product, battery, literature, or packaging reminds you that all
electrical and electronic products, batteries, and accumulators must be taken to separate collection at the end of
their working life. This requirement applies in the European Union. Do not dispose of these products as unsorted
municipal waste. Always return your used electronic products, batteries, and packaging materials to dedicated
collection points. This way you help prevent uncontrolled waste disposal and promote the recycling of
materials. More detailed information is available from the product retailer, local waste authorities,
national producer responsibility organisations, or your local Power Idea Technology (Shenzhen) Co., Ltd.
representative.
12. INFORMATION CONCERNING CE SAR CERTIFICATION
(SPECIFIC ABSORBATION RATE)
The SAR limit of Europe is 2.0 W/kg. The device has also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use at the ear is 0.681 W/kg and when properly
worn on the body is 1.121 W/kg. This device was tested for typical body-worn operations with the back of the
handset kept 5mm from the body. The device complies with RF specifications when the device used at 5mm
from your body. The use of belt clips, holsters and similar accessories should not contain metallic components
in its assembly. The use of accessories that do not satisfy these requirements may not comply with RF exposure
requirements, and should be avoided.

13. TRADEMARKS

All other trademarks and copyrights are the properties of their respective owners.
Meaning of indicator light
When receiving intercom voice communication, the green light will be on.
When PTT key is pressed to initiate intercom, the red light will go on.
When battery level is 0~99%, the red light is always on.
When the battery level is 100%, the green light is always on.
When there is a new message, the blue light flashes.
When the battery level is below 15%, the red light flashes.
EN
7