Automatic Power Off Function; Cleaning And Maintenance; Descaling Your Coffee Maker - Create THERA RETRO Manual Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

• Finally, Press the coffee/steam button "

pliance can produce steam normally when the yellow indicator light is on.

• If the steamer still doesn't work, please, contact our aftersales service.

The appliance will turn off automatically 29 minutes after pressing the ON/OFF button "

• Unplug the coffee maker and allow it to cool down completely before cleaning it.

• Clean the coffee maker housing with a damp cloth regularly and rinse the water tank, drip

tray and removable shelf and dry them right after.

Note: Do not clean the appliance with alcohol or any solvent cleaning products. Never im-

merse the housing in water for cleaning.

• Detach the metal filter holder by turning it clockwise, discard coffee residue inside, then

you can clean the filter holder with a mild cleanser and rinse it with clear water.

• Clean all the attachments and dry thoroughly.

Note: Do not wash the portafilter arm or the filter in a dishwasher.

1. To make sure your coffee maker is operating efficiently, make sure you are regularly cleaning

the internal piping. You should decalcify your coffee machine every 1-2 months to ensure the

best coffee flavour.

2. Fill the water tank with a solution of water and descaler to the MAX level (the ratio of water to

descaler should be 4:1; please refer to the instructions on the label of your descaler).

3. Follow the same instructions as for the preheating process and place the metal and pitcher

or cup of choice in place.

4. Press the ON/OFF button "

red. Make sure the steam button "

When there is water flowing out, close the pump immediately. Now the appliance is heating.

5. When the green light turns on the appliance will be heated. Now press the coffee button "

" and brew two cups worth of descaler (about 2oz). Then close the pump and wait 5 seconds.

6. Press the steam button "

min., then turn the steam knob to the "0" position. Press the ON/OFF button "

unit off immediately and let the descaler sit in the unit for at least 15 minutes.

7. Restart the unit and repeat the steps 4-6 at least 3 times.

8. Make sure that neither the coffee button "

When the green light comes on, press the coffee button "

isn't any descaler left.

9. Now repeat steps 4-6 with tap water (without descaler). Then brew until there isn't any water

left in the tank.

10. Repeat step 9 at least 3 times to make sure the piping is clean.