Cleaning And Disinfecting; Maintenance; Disposal And Recycling - Permobil Smart Check Manual De Instrucciones

Cleaning and Disinfecting

Warnings:
- Cleaning and disinfecting are separate processes. Cleaning must precede disinfection. Before use by a different individual, clean, disinfect, and
check product for proper functioning. When used by the same individual, clean and disinfect the product regularly and when it becomes soiled.
- Follow safety guidelines on cleaning and disinfecting product labels.
- Smart Check should not be cleaned with acetone, MEK, toluene, or adhesive removers.
Sterilization: Smart Check is not packaged in a sterile condition, nor is it intended or required to be sterilized prior to use. High temperatures
accelerate aging and cause damage to the product assembly.
Warning: DO NOT immerse Smart Check in liquid.
To Clean: Wipe Smart Check with mild detergent and a clean, soft cloth or a sponge. Air dry.
To Disinfect: Wipe Smart Check with bleach-free disinfecting wipe. Air dry.
Care Symbols Glossary:

Maintenance

Warning: DO NOT perform maintenance on Smart Check while it is in use. Doing so may result in improper functioning.
Daily: Inspect Smart Check quick disconnect, tubing, and device housing for wear or breakage, and to ensure inter-component attachment. DO
NOT continue to use Smart Check if any part is damaged or cannot be attached securely. Periodically, Smart Check should be inspected by a
qualified technician.
Battery Replacement
The low-battery light means the batteries should be replaced. Follow the instructions below.
Notes: Smart Check will remember your saved setting after battery replacement. • To
preserve battery life, Smart Check automatically goes into "sleep" mode when not in use. •
Expected service life of batteries: one (1) year.
1. Detach Smart Check from the cushion at the quick disconnect.
2. Use a Phillips head screwdriver with a non-conductive handle to loosen the screw and
open the battery door.
3. Use the screwdriver to release the batteries.
4. Refer to "+" and insert two (2) new 1.5 volt alkaline button cell batteries (LR44, A76,
AG13 or equivalent).
5. Close the battery door.
6. Tighten the screw.
Caution: If the screw is not tightened completely, the batteries may be exposed to
moisture, resulting in product damage.
Warning: KEEP BATTERIES OUT OF REACH OF CHILDREN AND ANY INDIVIDUALS WHO HAVE A
TENDENCY TO PLACE INEDIBLE OBJECTS IN THEIR MOUTHS. Swallowing or inhalation may lead to serious
injury or death. IMMEDIATELY seek emergency medical assistance.

Disposal and Recycling

Disposal: Dispose of the product and/or components in accordance with the applicable regulations in your jurisdiction, (including
electronic waste disposal). At the end of its useful life, treat as healthcare waste and dispose of according to local healthcare-waste
guidelines. DO NOT INCINERATE.
Recycling: Contact a local recycling agency to determine recycling options for the product.
Smart Check Operation Manual
Wipe with a damp cloth.
8
Do not bleach.
Low-Battery Light
Dry flat.
+