GYS WF 35 Manual De Uso página 120

Using the machine interface
Overload, please check your settings
019
Press and release the trigger to erase
Problem with welding start-up
020 Please check your welding parameters
Press and release the trigger to erase
USB overload
024
Disconnect your USB
An internal system error has occurred.
-
Please restart your product
- Calibration error
- The product's memory space is full.
File %s not supported
- Err %d
Continue anyway?
- Unable to write to USB stick
The USB stick is not recognised. The display of
- step 5 of the update procedure does not appear
on the screen (see general instructions).
If an error code which is not listed appears or your problems persist, contact your distributor.
20
Check the power source settings and installation (welding wire, rol-
lers, gas, torch, etc.)
If the problem persists, update the software (via Planet GYS).
Check the power source settings and installation (welding wire, rol-
lers, gas, torch, etc.)
If the problem persists, update the software (via Planet GYS).
Change the USB stick.
Turn the product off and on again.
If the problem persists, update the software (via Planet GYS)
Recalibrate the welding cables («Calibration» menu)
Delete Jobs to free up internal storage space.
The data on the USB stick is corrupted. Check your data.
Free up some space on the USB key.
If the problem persists, change the USB stick..
1- Insert the USB key into its socket.
2- Turn on the power source.
3- Hold down on the HMI thumbwheel to force the update.