Cleaning The Tool; Blade Maintenance - Makita XMU04 Manual De Instrucciones

If the chip receiver is attached to the blades, it gathers
discarded leaves and makes clean-up afterward much
easier.
To cut a hedge side evenly, cut from the bottom to top.
When trimming to make a round shape (trimming box-
wood or rhododendron, etc.), trim from the root to the
top for a beautiful finish.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

Cleaning the tool

Clean the tool by wiping off dust with a dry cloth or one
dipped in soapy water and wrung out.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.

Blade maintenance

Before the operation or once per hour during operation,
apply low-viscosity oil (machine oil, or spray-type lubri-
cating oil) to the blades.
After operation, remove dust from both sides of the
blades with a wired brush, wipe it off with a cloth and
then apply low-viscosity oil (machine oil, or spray-type
lubricating oil) to the blades.
16 ENGLISH