Safety Precautions - Cebora POWER ROD 250T - Cell Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
EN - INSTRUCTION MANUAL FOR ARC WELDING MACHINE
1
SAFETY PRECAUTIONS �������������������������������������������������������������������������������������������������������������������������������������11
1.1
........................................................................................................................................................ 12
2
GENERAL DESCRIPTIONS ������������������������������������������������������������������������������������������������������������������������������� 12
2.1
........................................................................................................................................................ 12
2.2
2.3
2.3.1 Thermal protection .................................................................................................................................................................. 13
3
INSTALLATION ��������������������������������������������������������������������������������������������������������������������������������������������������� 13
3.1
-
................................................................................................................................................................ 13
3.2
3.3
........................................................................................................................................................ 16
3.4
........................................................................................................................................................... 16
3.4.1 Preparing the electrode ........................................................................................................................................................... 16
4
ACCESSORIES ��������������������������������������������������������������������������������������������������������������������������������������������������� 16
5
MAINTENANCE �������������������������������������������������������������������������������������������������������������������������������������������������� 16
5.1
5.2
6
TECHNICAL SPECIFICATIONS ������������������������������������������������������������������������������������������������������������������������� 17
IMPORTANT: BEFORE STARTING THE EQUIPMENT, READ THE CONTENTS OF THIS MANUAL, WHICH MUST BE
STORED IN A PLACE FAMILIAR TO ALL USERS FOR THE ENTIRE OPERATIVE LIFE-SPAN OF THE MACHINE.
THIS EQUIPMENT MUST BE USED SOLELY FOR WELDING OPERATIONS.
1

SAFETY PRECAUTIONS

WELDING AND ARC CUTTING CAN BE HARMFUL TO YOURSELF AND OTHERS. THE USER MUST
THEREFORE BE EDUCATED AGAINST THE HAZARDS, SUMMARIZED BELOW, DERIVING FROM WELD-
ING OPERATIONS. FOR MORE DETAILED INFORMATION, ORDER THE MANUAL CODE 3301151.
NOISE
This machine does not directly produce noise exceeding 80dB. The plasma cutting/welding procedure may
produce noise levels beyond said limit; users must therefore implement all precautions required by law.
ELECTRIC AND MAGNETIC FIELDS- May be dangerous.
· Electric current following through any conductor causes localized Electric and Magnetic Fields (EMF).
Welding/cutting current creates EMF fields around cables and power sources.
· The magnetic fields created by high currents may affect the operation of pacemakers. Wearers of vital
electronic equipment (pacemakers) shall consult their physician before beginning any arc welding, cut-
ting, gouging or spot welding operations.
· Exposure to EMF fields in welding/cutting may have other health effects which are now not known.
· All operators should use the followingprocedures in order to minimize exposure to EMF fields from the welding/
cutting circuit:
- Route the electrode and work cables together
- Secure them with tape when possible.
- Never coil the electrode/torch lead around your body.
- Do not place your body between the electrode/torchlead and work cables. If the electrode/torch lead cable ison your
right side, the work cable should also be on yourright side.
- Connect the work cable to the workpiece as close as possible to the area being welded/cut.
- Do not work next to welding/cutting power source.
3301035/B
TABLE OF CONTENTS
........................................................................................................................... 13
.................................................................................................................................... 14
..................................................................................................................................... 17
........................................................................................................................................ 17
.................................................................... 13
11/13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Power rod 380t - cell514519

Tabla de contenido