Scott SOLACE GRAVEL eRIDE 30 Manual página 21

15 Error codes
The drive system is continuously monitored. In the event of an error, a corre-
sponding error code is shown on the Display.
Error code
ERR 401 DRV SW
ERR 403 DRV COMM
ERR 405 DISP COMM
ERR 407 DRV SW
ERR 408 DRV HW
ERR 40B DRV SW
ERR 40C DRV SW
ERR 40D DRV SW
ERR 40E DRV SW
ERR 40F DRV SW
ERR 415 DRV SW
ERR 416 BATT COMM
ERR 418 DISP COMM
ERR 41D DRV HW
ERR 41D DRV SW
ERR 42B DRV SW
ERR 42E DRV SW
ERR 440 DRV HW
ERR 445 DRV HW
ERR 451 DRV HOT
ERR 452 DRV HOT
EN - 20
Cause
General software error
Peripheral communication
error
Walk assist communica-
tion error
Drive Unit electronic error
Drive Unit overcurrent
error
General software error
Configuration error
General software error
Display initalization error
Drive Unit memory error
General software error
Drive Unit electronic error
Drive Unit overcurrent
error
Drive Unit over tempera-
ture error
Corrective measures
Restart the system. Contact
your TQ dealer if the error still
occurs.
Restart the system and avoid
unintended use. Contact your
TQ dealer if the error still occurs.
Restart the system. Contact
your TQ dealer if the error still
occurs.
Contact your TQ dealer.
Restart the system. Contact
your TQ dealer if the error still
occurs.
Restart the system and avoid
unintended use. Contact your
TQ dealer if the error still occurs.
Permissible operating tempera-
ture exceeded or fall below.
Switch off the drive unit to allow
it to cool down if necessary.
Start the system again. Contact
your TQ dealer if the error still
occurs.