omisa WeldControl 250 Manual De Uso página 39

O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
ress. Make sure nobody is present in the danger
zone.
Heating Element
When working with the product, be extremely cau-
tious while the heating element is being used. Since
Caution
the heating element presents a temperature of more
than 200°C (400°F) during the welding process, it is
absolutely indispensable that operators wear suit-
able protective gloves. Bear in mind that the heat-
ing element will remain hot for a while after it was
turned off.
Danger of Bruises and Injury
Do not remain in the danger zone while the car-
riage of the basic machine chassis moves apart or
Caution
closes in, and be sure not to have your arms or legs
between the moving and the fixed carriage of the
chassis.
Acceptable Work Conditions
The work zone has to be clean and has to have
proper lighting. It is dangerous to operate while it
Caution
is raining, in a humid environment, or close to flam-
mable liquids. In regard of this, acceptable work
conditions have to be ensured (tent, heating, etc.).
User's Manual
The User's Manual has to be available at any time
on the site where the welding system is used. If the
Info
User's Manual becomes incomplete or unreadable,
replace it without delay. Feel free to contact us for
assistance.
2.4 Owner and Operator Obligations
• The product may be operated exclusively by persons who
are familiar with the applicable rules, the guidelines for
the prevention of accidents, and the User's Manual. The
owner/manager shall provide the worker operating the
system with the User's Manual and shall make sure that
the operator reads and understands it.
• The system may be operated only when observed. Weld-
ers must have been briefed properly on the operation
of the system or must have participated in a dedicated
training. The operating/owning organization engages
to check and make sure at reasonable intervals that the
system is operated by the welders as intended and un-
der proper guidelines of occupational safety.
• The product must be operated only when in proper state
of repair and for one of the intended uses. Before weld-
ing, the welder is required to make sure that the state
of the system is in order.
Version November 2022_1 Weld Control 250 User's Manual
7
EN