omisa WeldControl 250 Manual De Uso página 41

O . M . I . S . A . S r l
Via Verga 9/11
20845 Sovico (MB), Italy
3 Understanding the Product
This butt-welding system for plastics can be used both as
an on-site and as a workshop installation, for jointing op-
erations pipe-to-pipe, but also for processing tees and el-
bows (see Sect. 3.4 for more detailed information). The sys-
tem enables welding according to two modes, the Manual
Mode and the Data Logging/Report Generation mode, or
Weld Control Mode for short.
3.1 Content of Delivery
• RFID card with access code of configuration menu
• Tools
• Machine chassis ("basic machine") to secure the parts to
be welded
• Electrical heating element with anti-stick coating
• Electrical facing tool
• Carrying and storage rack for heating element and fac-
ing tool
• Hydraulic and control unit with control panel
• Reducer inserts in the applicable range (refer to Sect. 3.4)
for clamps
• Transport box (model versions with basic machine chas-
sis up to 315 mm)
3.2 Control Panel
Version November 2022_1 Weld Control 250 User's Manual
Welding Process Diagram
Pressure Release Valve
Display Screen
Maximum Pressure Regulator
MENU and Cursor Keys
Oil Refill Nipple with Level Probe
START/SET and
STOP/RESET Keys
Carriage Mover Lever
9
EN