Troubleshooting; Declaration Of Conformity; Gs Tested Safety Mark - Olympia PS 16 Manual De Instrucciones

10. Troubleshooting

Problem
Device does not
work
Device no longer
functions after a
longer period out
of service or stops
during operation
Paper jam
Note! If you cannot clear the fault yourself, contact your dealer or call the GO Europe
hotline.

11. Declaration of Conformity

The CE Mark on the device confirms conformity.
The Declaration of Conformity can be read online at www.go-europe.com.

12. GS tested safety mark

1000000000
its intended use and in the event of foreseeable misuse the identified product will not
endanger the safety and health of the user. It concerns a voluntary safety mark which
was issued by an authorized testing institute.
24
Diagnosis & Cause
Is the power plug connected
properly in the power socket?
Is the sliding switch set to
Auto?
Does the motor fail to start
when paper is inserted?
Was the device shutdown for
a longer time? Is the surface of
the device hot? The permissible
continuous operation time has
probably been exceeded.
Have you exceeded the permis-
sible paper capacity (refer to
Chapter "Technical Data")? Has
the paper been fed in askew?
The «Geprüfte Sicherheit» mark (GS tested safety mark) certifies
that the product satisfies the requirements defined by the German
Product Safety Act (ProdSG).
The GS tested safety mark indicates that when implemented for
Solution
Connect the power plug in the
power socket properly.
Set the sliding switch to
Auto.
Slide the paper in the respec-
tive infeed slot so that it makes
contact with the sensor in the
middle.
First of all, disconnect the
power plug from the power
socket and allow the motor
to cool down to room tem-
perature. For informationon
continuous operation, refer to
Chapter "Technical Data".
Clear the paper jam, refer to
Chapter "Clearing a paper
jam".
G