Mount The Hood - GE JNXR22 Manual Del Propietario E Instalación

POWER SUPPLY
IMPORTANT – (Please read carefully)
WARNING
FOR PERSONAL SAFETY, THIS
APPLIANCE MUST BE PROPERLY GROUNDED.
Remove RV fuse or open circuit breaker before
beginning installation.
Electrical supply
These vent hoods must be supplied with 12V DC,
and connected to an individual, properly grounded
branch circuit, and protected by a 15 amp circuit
breaker or fuse.
• If the electrical supply does not meet the above
requirements, call a licensed electrician before
proceeding.
• Route RV wiring as close to the installation
location as possible in the ceiling or wall.
• Connect the wiring to the RV wiring in accordance
with local codes.
Grounding instructions
The grounding conductor must be connected to
a ground metal, permanent wiring system, or an
equipment-grounding terminal or lead on the hood.
WARNING
The improper connection of the
equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician
or service representative if you are in doubt whether
the appliance is properly grounded.
1
PREPARING MOUNTING
To install to the bottom of cabinet
Measure the cabinet bottom per diagram below
and mark the 4 holes. Use the hood as a
template making sure the bottom of the cabinet
is flush with the RV internal wall.
Drive the 4 wood screws partway into the
bottom of the cabinet (or wood shims).
7-1/2"
2-1/16"
Bottom of Cabinet View
8
Installation Instructions
18"
9"
Center
RV Wall
Line
2

MOUNT THE HOOD

1. RECIRCULATION MODEL: Push the hood
into the cabinet opening until the back of
the hood is parallel with the RV wall.
VENTED MODEL: Push the hood into the
cabinet opening until the exhaust port on
the hood is seated into the damper opening
provided in the RV wall (damper not
included with hood). Make sure the hood is
parallel with the RV wall.
2. Make sure the hood is level with the bottom
of the cabinet.
3. Drive the 4 mounting screws up from the
bottom of the hood securing them in the
bottom of the cabinet.
Vent Opening on
Vented Hood
49-2001088 Rev. 2