Charcoal Filters; Grease Filters; Hood Lights; Painted Surfaces - GE Energy Star JVE40 Manual Del Usuario

Care and cleaning of the vent hood.
The charcoal filters are clipped
inside of each reusable metal
grease filter.
49-80622-5

Charcoal Filters

(on some models)
The charcoal filters
cannot be cleaned.
They must be replaced.
Order Kit no.
WB02X11000.
This kit can be ordered
from your GE supplier.

Painted Surfaces

(on some models)
To clean the hood surface, use a hot, damp
cloth with a mild detergent suitable for
painted surfaces. Use a clean, hot, damp
cloth to remove soap. Dry with a dry, clean
cloth.

Stainless Steel Surfaces

Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use
warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface in
the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel
surface.

Hood Lights

WARNING:
Hg
- Lamp contains Mercury. Manage
in accord with disposal laws. See www.
lamprecycle.org or 1-800-435-4448.
For installation, handling and disposal
precautions, refer to the fluorescent lamp
packaging literature.
WARNING:
To reduce the risk of electric shock, do
not connect electrical power to the hood
without both lamps in place.
CAUTION:
Do not touch the hood lamps when they are
on. They may be hot enough to cause injury.
To prevent injury from broken lamps,
handle lamps carefully and do not operate
hood without lamp lens covers in place.
NOTE: Charcoal filters are not
included with the hood. They
must be ordered from your
GE supplier.
If the model is not vented
to the outside, the air will
be recirculated through
disposable charcoal filters that
help remove smoke and odors.
Do not use steel-wool pads or other abrasive
cleaners. They will scratch the surface. Wipe
with a clean, hot, damp cloth after using
cleansers.
(on some models)
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
National Parts Center
GEAppliances.com
This hood requires two Compact Fluorescent
Lamps (CFL) with a GU24 base (included),
maximum 15 watts.
To change the lamps:
When installing or replacing a lamp,
make sure that power to the light has
been turned off. Never allow a lamp to
come into contact with water.
Remove the lens cover by sliding it in a
horizontal direction and pulling it down
and away from the hood.
Grasp the lamp by the plastic base
portion of the lamp and unscrew it.
Replace with energy saving GE 15W
Compact Fluorescent Lamp with GU24
GEAppliances.com
The charcoal filters should
be replaced when they are
noticeably dirty or discolored
(usually after 6–12 months,
depending on hood usage).
NOTE: DO NOT rinse, or put
charcoal filters in an automatic
dishwasher.
Note: If the hood is installed
for recirculation mode, it is
not E S certified.
®
NERGY TAR
800.626.2002
5