Descargar Imprimir esta página

Bosch NGMP077UC Instrucciones De Instalación página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

en-us Installation procedure
Check to make sure that there is no gap between the
2.
burner parts. You may gently try to move the burner
parts from side to side to check if they are properly
seated.
4.9 Installing the burner grates
WARNING
Improperly positioned grates can cause flare-ups.
Position all grates properly on the cooktop whenever
the cooktop is in use to properly support pots and avoid
spills.
Make sure each of the four feet of the grates is placed
into the corresponding dimples on the cooktop surface.
Do not use a grate if the rubber feet are missing or
damaged.
Flame characteristics
The color of the flame tells you if the gas supply is properly adjusted.
Note: Allow the appliance to operate for 4 to 5 minutes before evaluating the flame. Some yellow streaking is normal dur-
ing the initial startup.
Flame
Image
Completely or mostly
yellow
Yellow tips on outer
cone
14
4.10 Checking the installation
Check if your unit is working properly after you have com-
pleted the installation steps.
WARNING
Before you turn on power supply, make sure all controls
are in the OFF position.
Ensure that the burner caps are properly positioned.
1.
Turn each burner on in turn and verify that the electric
2.
igniters are working.
Turn the control knob between the highest and lowest
3.
setting. Make sure the flame does not go out and there
are no flashbacks.
If you have carried out an LP gas conversion, check the
4.
lowest setting to confirm the flames are stable on the
ports and the set screws do not need to be readjusted.
Check the flame characteristics.
5.
The flame should be blue with a minimal yellow tip on
the outer cone.
After completing all checks, complete the installation of
6.
the horizontal panel or oven. →  Page 9
Note: The appliance is shipped from the factory for use
with natural gas. If you want to use propane gas, it must
be converted. A qualified technician or installer must do
the conversion. Refer to Conversion to LP gas.
Measure
Verify that the regulator is set for the correct fuel. Retest af-
ter adjustment.
Normal for LP gas

Publicidad

loading