Important Safety Precautions - Herschel HS500PR Instrucciones De Instalación Y Funcionamiento

IMPORTANT SAFETY PRECAUTIONS

Failure to observe these instructions will invalidate the warranty.
Do not disassemble. No user-serviceable parts inside.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY
This appliance must be disconnected from its power source during setup or service activities and when replacing.
The heater is equipped with a sensor providing temperature control of the unit and the surrounding area.
Nevertheless the panel surface can rise to 90°C / 194°F (depending upon input voltage) and must not be operated in
locations where people can fall or become immobile next to the heater.
DO NOT
touch the heater when in use. Prolonged contact with the heater will cause burns and injury.
The heater has internal safety thermal cut out sensors. However, in order to avoid overheating and potential fire
DO NOT
hazard, cover the heater under any circumstances.
flammable materials (eg. Furniture, curtains).
DO NOT
operate the heater if the cord or plug is damaged or after the heater malfunctions, or if it has been
dropped or damaged in any manner. Make sure that the heater itself, the plug and the cable are free of any visible
signs of damage. If the cord is damaged the appliance must be sent for repair to an authorised Herschel Dealer.
This heater must only be used for the heating of people or buildings. The heater is not to be used by children or
persons with reduced physical, sensory or mental capabilities, or lack of experience or knowledge. Children should
be kept away and should not be left unsupervised around the unit.
All operators should only switch on/off the appliance provided that it has been placed or installed in its intended
operating position in accordance with these instructions. Children must not plug in, switch on or regulate the
appliance or perform user maintenance including cleaning.
The heater must be mounted on a non-flammable surface. To avoid the heater tipping over the surface must be
horizontal, even and un-broken.
DO NOT
place this heater directly underneath mains sockets.
Herschel panels are designed for use with an AC voltage between 220-240 volts, 50 Hz AC. If your supply voltage
exceeds 240 Volts do not use the heater and refer to your local dealer. Failure to adhere to this will void the
warranty.
This heater is a Class 1 appliance and must be earthed. The electrical supply to each heater should be protected by a
fuse or residual current device with overcurrent protection (RCBO) or Ground Fault circuit interrupter (GFCI )
suitable for the electrical rating of the appliance.
For certain public buildings like schools and care homes the heaters must be operated according to the specific
legislation for these types of buildings. Please check before use.
Select Portable Infrared Panel Heater
DO NOT
locate the heater within 400mm of any
DO NOT
use outdoors.
ENGLISH