Medion P66400 Manual De Instrucciones página 345

17.3.2. Search
 Select SCAN to start a station search immediately. A progress bar indicates the
search progress.
Once the search is complete, the list of stations is displayed.
17.3.3. Manual setting
Under MANUAL TUNE, channels 5A to 13F are shown on the display with the
corresponding frequencies.
 Select a channel and press SELECT to confirm.
 The reception strength is displayed. Press SELECT again to confirm.
The new, additional stations are stored in the station list.
17.3.4. Cleaning the list of stations
If you operate the device in a different location, you will need to carry out a new
search. Stations that are no longer available are then marked with a question mark
in the station list.
 Select PRUNE INVALID and confirm the subsequent prompt by pressing YES
to delete stations that are no longer available from the list of stations.
17.3.5. Dynamic Range Control
Dynamic Range Control (DRC) is helpful during quiet parts of a radio programme
and in noisy environments. The station sets the DRC level of the radio transmission.
Using the Dynamic Range Control function you can set the optimum level for you.
• DRC off: DRC is switched off. The DRC level of the radio transmission is not used.
• DRC low: the DRC level is set to half of the transmitted level.
• DRC high: the total DRC level is set.
17.3.6. Station sort sequence
 Set the station sort sequence for the list under STATION ORDER:
ALPHANUMERIC
•
Stations are sorted in alphabetical and numerical order.
ENSEMBLE
•
Stations are sorted by DAB ensemble.
18. Listening to FM radio
You can play analogue radio stations using the FM operating mode. A good
reception via the integrated telescopic aerial is required for this. Align the aerial
manually to obtain the best-possible reception.
 To listen to FM radio, select FM in the main menu and then press SELECT on the
remote control to confirm or press the
and press the SELECT button to confirm.
346
button and use the dial to select FM