Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING YOUR IRON,
BASIC SAFETY PRECAUTIONS
SHOULD ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS
BEFORE USING YOUR IRON.
POLARIZED PLUG:
This appliance has a polarized plug
(one blade is wider than the other).
As a safety feature, this plug will
fit into a polarized outlet only one
way. If the plug does not fit fully
into the outlet, reverse the plug. If it
still does not fit, contact a qualified
electrician. Do not attempt to
defeat this safety feature.
SAVE THESE INSTRUCTIONS
For Household Use Only
TOLL FREE: 1-800-798-7398
1. Use iron only for its intended use.
2. To protect against risk of electrical
shock, do not immerse the iron
in water or other liquids. Always
turn the iron to "MIN/LOW" before
plugging in or unplugging from
outlet.
3. Never yank cord to disconnect
from outlet. Grasp plug and pull
to disconnect.
4. Do not allow cord to touch
hot surfaces. Let iron cool
completely before putting away.
5. Always disconnect iron from
electrical outlet when filling with
water, emptying, or when not
in use.
6. Do not operate iron with a damaged
cord, or after the iron has been
dropped or damaged in any manner.
To avoid the risk of electric shock,
do not disassemble the iron. Return
the iron to EURO-PRO Operating
LLC for examination and repair.
Incorrect reassembly can cause
the risk of electric shock when
the iron is used.
7. Close supervision is necessary for
any appliance being used by or
near children. Do not leave iron
unattended while connected or on
an ironing board.
8. Burns can occur from touching
hot metal parts, hot water or
steam. Use caution when you turn a
steam iron upside down; there may
be hot water in the reservoir.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not
operate another high-wattage
appliance on the same circuit.
2. If an extension cord is absolutely
necessary, use a 13-ampere cord.
Cords rated for less amperage may
overheat. Use care to arrange the
cord so that it cannot be pulled or
tripped over.
3. Do not rest iron on soleplate.
4. Never use or rest iron on an unstable
surface.
5. While the iron is hot, never set iron
on an unprotected surface - even if it
is on its heel rest.
6. WARNING! TO PREVENT ELECTRIC
SHOCK OR OTHER INJURY, before
filling the iron with water, make sure
that the plug is removed from
the outlet.
7. CAUTION: Never fill the iron with
fabric conditioner, starches or any
other solution, as these will
damage the steam mechanism.
Do not use contaminated water.
8. WARNING! TO AVOID FIRE, never
leave iron unattended while it is
plugged in.
9. WARNING! TO PREVENT
ELECTRIC SHOCK, never immerse
the iron in water or other liquid.
10. WARNING! TO PREVENT
ELECTRIC SHOCK, never use the
iron in a location where it can fall
or be pulled into water or any
other liquid. If the iron falls into
water or any other liquid, unplug it
immediately. DO NOT reach into
the water or liquid.
11. CAUTION: Never use scouring
pads, abrasive or chemical cleaners,
or solvents to clean the exterior or
soleplate of your iron. Doing so will
scratch and/or damage the surface.
12. WARNING! DO NOT aim iron at
face, towards yourself, or anyone
else while using or adjusting steam.
Burns or serious injury may occur.
13. Always store your iron in the
upright position, not on the
soleplate. If stored face down, even
the smallest amount of moisture will
cause the soleplate to corrode
and stain.
14. DANGER! Never use the iron if
it is damaged or dropped.
Using the iron when it is damaged
could create the risks of fire, electric
shock, injury or death.
www.sharkcompany.com
English
Publicidad
