Basic Operation - Esoteric RZ-1 Manual Del Usuario

Remote Control Unit (2)
Battery Replacement
If the distance required between the remote control unit and main
unit decreases, the batteries are exhausted. In this case replace the
batteries with new ones.
For more information about collection of batteries, please contact
your local municipality, your waste disposal service or the point of sale
where you purchased the items.
Precautions concerning batteries
Misuse of batteries could cause them to rupture or leak leading
to fire, injury or the staining of nearby things. Please read and
observe the following precautions carefully.
< Be sure to insert the batteries with correct positive (+) and
negative (_) orientations.
< Use batteries of the same type. Never use different types of
batteries together.
< Both rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
< If the remote control will not be used for a long time (more than a
month), remove the batteries to prevent them from leaking.
< If the batteries leak, wipe away the leakage inside the battery
compartment and replace the batteries with new ones.
< Do not use batteries of types other than those specified. Do not
mix new batteries with old ones or use different types of batteries
together.
< Do not heat or disassemble batteries. Never throw batteries into
fire or water.
< Do not carry or store batteries with other metallic objects. The
batteries could short circuit, leak or explode.
< Never recharge a battery unless it is confirmed to be a
rechargeable type.
14

Basic Operation

1
Press the STANDBY/ON button to turn the unit on.
The blue indicator lights.
< Turn on the power of the connected devices before you turn on
the RZ-1.
2
Press the SOURCE button repeatedly to select an input
source.
The selected source is shown on the display.
Each time the SOURCE button is pressed, the source changes as
follows:
CD/SACD
COAX
OPT
USB
LINE1
LINE2 or PHONO*
* When you use LINE2 as PHONO input, select "PHONO" in "L-2"
setting (page 22 "LINE2/PHONO terminal").
< You can also use the INPUT (
control unit to select a source. If you press the
source changes in the opposite order of that shown above.
< When set to COAX, OPT or USB, if no input device is connected
to the selected terminal, or this unit is unable to lock with that
device, instead of the sampling frequency being shown, the
name of the input source will blink. Check the connections.
/ ) buttons on the remote
button, the