Available setup items and settings
H
BAL > (Speaker balance)
Use this to adjust the left/right speaker output balance.
The higher the R value, the more the sound will be balanced to
the right speaker. The higher the L value, the more the sound will
be balanced to the left speaker.
R3.0 (dB)
(0.5dB steps)
0.0
(0.5dB steps)
L3.0 (dB)
H
TREBLE >
Adjusts the level of high frequency sound range.
The higher the number, the more the high frequencies are
emphasized.
+10
−10
H
BASS >
Adjusts the level of low frequency sound range.
The higher the number, the more the low frequencies are
emphasized.
+10
−10
(Center)
0
(Flat)
0
(Flat)
H
DF > (Digital filter)
Changes the digital filter of D/A converter.
FIR
A 32-bit FIR digital filter (Finite impulse response) oversamples the
input signal to 8 times the frequency of the original signal. This
provides a fuller, richer and deeper sound.
S_DLY (Apodizing filter type)
A 32-bit short delay filter oversamples the input signal to 8 times
the frequency of the original signal. This provides an impulse
response without pre-echo, natural attack and reverberation. This
setting provides tonal quality that is closer to the original and
without enhancement.
H
L-2 > (LINE2/PHONO terminal)
Changes the phono equalizer setting of LINE2.
LINE
The phono equalizer is not used. Use this setting for ordinary line
level equipment.
PHONO
The phono equalizer is used. Use this setting when connecting a
record player with MM (Moving Magnet) type cartridge.
< When using an MC (Moving Coil) type cartridge, an external step-
up transformer or similar equipment is necessary.
< When connecting an external phono amplifier such as an
ESOTERIC E-03, set the unit to "LINE."
H
DIMMER >
Changes the brightness of the display and indicator lamps.
The DIMMER button on the remote control has the same function
(page 15).
3
2
1
0
< In off mode, when you press a button, the illuminations turn
temporarily on for 3 seconds.
< In setup mode, the illuminations turn on with full brightness.
23