EGO HT2600E Manual De Instrucciones página 7

WARNING:
To avoid serious personal injury, always
remove the battery pack from the product when cleaning
or performing any maintenance.
CLEANING
◾
Use a soft brush to remove debris from all air intakes
and cutting blade.
◾
To remove pitch and other sticky residue, spray the
blades with resin solvent. Run the motor briefly so that
the solvent is evenly distributed.
◾
Wipe the surface with a dry cloth.
WARNING:
Never use water for cleaning your
trimmer. Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage from
various types of commercial solvents. Use clean clothes to
remove dirt, dust, oil, grease, etc.
SHARPENING THE CUTTING BLADE
1. Start and stop your hedge trimmer until the cutter
blade and the guard are slightly offset, as shown in
Fig. G. This will allow clearance for the file between
cutter teeth and guard teeth.
2. Remove the battery pack from your hedge trimmer.
3. Clamp the blade assembly in a vise and file the
exposed cutting surface of each blade tooth. Remove
as little material as possible. Be sure to retain the
original angle of each tooth when filing.
4. Remove the hedge trimmer from the vise; restart it
and stop it to expose the unsharpened edges of the
blade teeth.
5. Remove the battery pack and repeat the sharpening
procedure above.
NOTICE:
Do not operate your hedge trimmer with dull or
damaged cutting blades. This may cause overload and
will give unsatisfactory cutting results.
LUBRICATING THE BLADE (Fig. H)
For best operation and longer blade life, lubricate the
hedge trimmer blade with light weight machine oil before
and after each use.
Remove the battery pack and lay the trimmer onto a flat
surface. Apply the oil along the edge of the top blade.
NOTICE:
For extended using period, oil the blade during
cutting operation.
WARNING:
Do not oil while the hedge trimmer is
running.
TRANSPORTING AND STORING
◾
Always place the blade guard on the blade before
storing or transporting the hedge trimmer. Use caution
to avoid the sharp teeth of the blade.
◾
Clean the hedge trimmer thoroughly before storing.
◾
Store the hedge trimmer indoors, in a dry place that is
inaccessible to children.
◾
Keep away from corrosive agents such as garden
chemicals and deicing salts.
blade assembly, wear non-slip, heavy-duty protective
gloves. Do not place your hand or fingers between blades
or in any position where they could get pinched or cut.
NEVER touch blades or service the unit with battery pack
installed.
Protecting the environment
56 VOLT LITHIUM-ION CORDLESS HEDGE TRIMMER— HT2600E
WARNING:
Blades are sharp. When handling the
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for separate
collection. Electric tools must be returned
to an environmentally compatible
recycling facility.
EN
7