Danby DUFM068A1SCDB Manual Del Propietário página 7

CARE & MAINTENANCE
CLEANING
• Ensure the appliance is unplugged before
cleaning.
• Clean the inside and outside of the appliance
with a soft, damp cloth and some mild
detergent.
• It is important to keep the area where the door
seals against the cabinet clean to ensure a tight
seal. Clean this area with a soapy cloth. Rinse
with a damp cloth and dry.
• Do not use cleaners containing ammonia or
alcohol as these can damage the appearance
of the appliance. Never use any commercial or
abrasive cleaners or sharp objects on any part
of the appliance.
• Allow the interior of the appliance to completely
dry before plugging it back in and returning
food items.
DEFROST
This appliance should be manually defrosted
approximately every 6 months or whenever the
layer of frost reaches 6 mm (1/4") thick.
Protect fl ooring by putting towels or a pan under the
appliance in case of leaking. Check the appliance
frequently during defrosting. Remove all food,
unplug the appliance and leave the door open.
Allow the frost to melt and leave the appliance
unplugged with the door open until the interior is
dry.
POWER FAILURE
Most power failures are corrected within a few
hours and should not affect the temperature of your
appliance if you minimize the number of times the
lid is opened. If the power is going to be off for
a longer period of time, take the proper steps to
protect your contents. Wait 3 to 5 minutes before
attempting to restart the refrigerator if operation
has been interrupted.
VACATION
You may leave the appliance operating during
vacations of less than three weeks. If the appliance
will not be used for several months, remove all items
and unplug the appliance. Defrost, clean and dry
the interior thoroughly. To prevent odor and mold
growth, leave the door open slightly, blocking it
open if necessary.
ENERGY SAVING TIP
The appliance should be located in the coolest area
of the room, away from heat producing appliances,
and out of direct sunlight. Do not overload the unit
or block any ventilation openings.
MOVING
• Remove all items and ensure the interior of the
appliance is clean and dry.
• Tape the lid shut.
• Be sure the appliance stays secure in the upright
position during transportation.
• Protect the outside of the appliance with a
blanket or similar item.
• If the appliance is placed on its back or side
during transportation, upon reaching the
destination, allow it to remain in its operating
position for 6 hours to reduce the possibility of a
malfunction in the cooling system.
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling
of electrical components. For information on local
waste collection points, contact your local waste
removal agency or government offi ce. Disposal of
this appliance should be in accordance with federal
and local regulations.
6