Bowers & Wilkins Pi5 S2 Manual De Instrucciones página 4

4. Stowing the Earbuds
When not in use, the Pi5 S2 earbuds should be
stowed inside the charging case, where they will be
recharged for future use.
5. Battery Charging
Pi5 S2 ships with the charging case and earbud
batteries partially charged and may be used
immediately. However, we recommend fully charging
the earbuds and case before first use. Please allow
up to 3 hours to fully charge.
To charge the Pi5 S2 earbuds:
With the earbuds in the charging case
1. Place the Pi5 S2 earbuds in the charging case.
2. Close the charging case lid.
To charge the Pi5 S2 charging case:
1. Use the supplied USB charging cable and
connect one end to a USB wall charger or a
powered computer USB port.
2. Connect the other end to the USB-C socket on
the charging case.
Note: While charging, the case indicator will
flash green. When fully charged, the indicator will
light solid green. The case can be charged with
or without the earbuds being housed inside the
case.
To charge the Pi5 S2 case using a wireless charging
With the earbuds removed from the charging case
station:
1. Place the charging case onto the centre of your
wireless charging station (not supplied).
2. Ensure that the rear of the charging case is on
the charging station (with the case indicator
facing up).
Note: While charging, the case indicator will flash
green. When fully charged, the indicator will light
solid green.
5.1 Status Indicator
The status indicator is located on the front of the
case. When the earbuds are placed in the case,
the LED provides information about the earbuds.
When the earbuds are removed from the case, the
LED provides information on the charging case. See
Diagram 3 and the tables that follow for LED states.
Battery levels can also be viewed in the
Bowers & Wilkins Music app.
Diagram 3
Status indicator illuminations
Illumination
Status LED states with the earbuds in the charging case:
Illumination
Flashing Green
(case lid open)
Flashing Yellow
(after power on)
Flashing Red
(after power on)
Solid Red
Flashing Blue
Solid Blue
(for 3 seconds)
Illumination
Status LED states with the earbuds removed from the charging case:
Illumination
Flashing Green
(case lid open)
Flashing Yellow
(after power on)
Flashing Red
(after power on)
Solid Red
Operational state
Operational state
Earbud battery charge >40%
Earbud battery charge between 20% and 40%
Earbud battery charge <20%
Hardware reset/system crash
Pairing successful
Bluetooth pairing mode enabled
Bluetooth pairing successful
Operational state
Operational state
Case battery charge >40%
Case battery charge between 20% and 40%
Case battery charge <20%
Hardware reset/system crash
4