Craftmade Maddie Guia De Instalacion página 8

7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy
to hanging bracket. Place rounded part of slotted hole
in canopy over loosened screw in hanging bracket
and push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screwheads
in bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
8. Blade Assembly.
WARNING: To reduce the risk of serious
bodily injury, DO NOT use power tools to
assemble the blades. If screws are
overtightened, blades may crack and break.
Locate 12 blade attachment screws/washers
in hardware pack. Hold blade arm up to blade
and align holes. Insert 3 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat for the remaining blades.
Remove blade arm screws/lock washers from
underside of motor (save blade arm
screws/lock washers to secure blade arms).
Align blade arm holes with motor screw holes
and attach blade arm with blade arm
screws/lock washers. Before securing screws
permanently, repeat with remaining blade
arms. Securely tighten all screws.
IMPORTANT: Tighten blade arm screws twice
a year.
canopy
screw
page 8
hanging bracket
screw
canopy cover
motor housing
blade
attachment
screws/
washers
blade
blade arm
blade arm screws/lock washers