Publicidad
Idiomas disponibles
Idiomas disponibles
Start Up
Useful tips
• Work placing the disc in the right position to prevent damage..
• Press the work piece applying pressure lower than the tool's weight to prevent overload
damaging the motor and disc.
• After installing a new disc allow it to run unloaded at least one minute. If vibration occurs
replace immediately.
• Avoid working onto wood or soft materials like lead. These materials saturate
CAUTION
the disc very quickly making it useless.
Maintenance
• Always disconnect the tool before cleaning.
• Never use water or other liquids. Use only a brush.
• To prevent the motor to overheat clean the ventilation slots regularly.
• Check all the tool components are perfectly fixed.
• The housing should not be cracked or damaged.
• Double-check the power cable is not cut or peeled.
• After a prolonged use the grease on the tool head should be replaced in a
Authorized Service Center.
Repairs
Use only spare parts and accessories recommended by the manufacturer. In
the event the tool is not working, repairs should be performed in a
Authorized Service Center
Carbon brush replacement
• Replace worn (burnt, broken or smaller than 0.19" long) carbon brushes.
Use new carbons.
• When changing carbons always change both carbons at the same time.
• Remove worn carbons from the housing. Clean dust with compressed air.
• Set the new carbons in a reverse order. Carbon should easily fall into the
carbon housing.
• After setting up new carbon brushes let the grinder to run a couple of
minutes with no load. This way the carbon brushes will adjust better.
• Use only original
specifically with the right strength and electric resistance for each type of
motor. Carbon brushes with different specifications may damage the motor.
• For better results, it is recommended to use grinding and/or cutting disc to
7"
Storage
Neatly store the tool in a dry place and protected from dust and water .
spare carbon brushes, designed
9
ENGLISH
Publicidad
