Publicidad
Idiomas disponibles
Idiomas disponibles
7. Wall mounting
Wall mounting of electric radiators must be carried out according
to the instructions contained in the fastening support package
and the figure below. The fastening systems (screws+blocks)
are suitable for compact walls or hollow brick walls. For walls
made of different materials, the installer is responsible for the
use of suitable fastening systems. Do not position the radiator
in front of the power socket. The radiator must not be installed
immediately below a power socket.
8. Connection
Before connection, make sure that the equipment rated voltage
(230 Vac 50 Hz) is equal to the mains voltage, and that the
socket is able to provide the rated current corresponding to the
maximum power of the model selected. Moreover, such socket
must be controlled through a double-pole switch used to switch
the radiator on and off. In case of damage, the power cable of
these radiators can be replaced. Such repair must be carried
out solely and exclusively by the manufacturer.
9. Installing the RF remote control
The RF remote control can be installed either on the wall or
placed on a table using the table stand.
•
Wall installation:
a)
Unscrew the 2 screws under the thermostat and remove
the wall support.
Code 1910000000356 - nv02
power supply cable
dimensions in mm
b)
Fasten the panel to the wall with the two screws supplied,
using the horizontal and vertical holes
•
Table stand
a)
Insert the 2 pins into the wall panel
b)
Slide the support to the right
•
Installation of batteries
a)
Remove the battery compartment cover on the front of
the thermostat
b)
Insert the 2 AA batteries supplied. When inserting
batteries, take care that the polarity is correct, according to the
indication on the thermostat
c)
Reposition the battery compartment cover
10.
RF
receiver/remote
connection
The RF remote control and RF receiver are not connected as
standard.
A maximum of 5 RF receivers can be connected to each RF
remote control, i.e. five different products which, however, will
work in the same mode and with the same settings.
•
RF connection
a)
Switch on the receiver by pressing the key
b)
Activate the connection mode on the receiver
by pressing the memo key for 5 sec.
The LED indicator on the receiver will start flashing in RED
c)
Activate the connection mode on the remote control by
- 25 -
English
control
Publicidad
