Publicidad
Idiomas disponibles
Idiomas disponibles
PIN code initialisation
By default, the PIN code is not enabled. =
1- The default PIN code is 0000.
Use
or
to select digit 0. 0 flashes, confirm it by
pressing
.
1
2- For the remaining digits, select digit 0 by pressing
When 0000 is displayed, press
The PIN code is initialised and the device automatically
suggests the following setting: PIN code activation.
Activating / deactivating the PIN code
The screen displays
Press
or
to enable the PIN code
= PIN code enabled.
= PIN code enabled
Press
to confirm and move to the next setting.
The PIN code has been enabled.
The settings listed under "Overview" cannot be changed.
PIN code customisation
When
is displayed, press
The code 0000 is displayed and the 1st digit flashes.
With
or
, select the desired digit and then press
confirm it.
Proceed in the same way for the remaining three digits.
Code 1910000000356 - nv02
2
.
again to confirm.
for at least 5 seconds.
5 sec
to
1
Press
to confirm. The new code has been stored. Press
again
to close the PIN code configuration mode and return
to the beginning of the installer settings.
Press 3x
to confirm and close the installer settings.
Reset to factory settings
If PIN code protection is disabled, user and installer settings can
be reset to their original values.
is displayed
flashes
Press
or
to select
Press
for 5 seconds.
The device returns to the original configuration and automatically
activates the Auto mode.
- 35 -
English
2
Publicidad
