Cordivari Window 1100 Electric Manual De Uso página 28

English
Mode sequences:
Auto Comfort
General mode description:
• mode
In automatic mode, the device automatically switches from
Comfort mode to Eco mode according to the set program.
Three different cases depending on the settings:
1. Weekly and daily program
The device has been programmed and is performing Comfort
and Eco mode commands in line with the selected settings
and time periods (see chapter "Integrated weekly and daily
program").
2. Control through communication cable (Fil Pilote, France only)
3. Weekly program not set
If the weekly program is not set, the radiator will operate
permanently in Comfort mode.
Comfort mode
Non-stop comfort mode. The device will run 24 hours a day to
reach the set temperature (e.g. 19°C in case of heating with
ambient temperature setpoint and 60°C in case of heating
with surface temperature setpoint). The temperature level of
Comfort mode can be set by the user.
• Eco Mode
Eco mode results in a reduction of Comfort mode temperature
by 3.5°C in case of heating with ambient temperature
setpoint mode and reduced by 3.0°C in case of heating with
surface temperature setpoint mode. This allows to lower the
temperature without changing the Comfort mode setting. Select
this mode for short absences (between 2 and 24h) and at night.
Frost pro-
Eco
tection
- 28 -
• Frost protection mode
This mode allows you to protect your home against the effects
of cold (frozen pipes, etc.) while maintaining a minimum
temperature of 7°C at all times with ambient temperature
setpoint, 10.0°C with surface temperature setpoint. Select this
mode for long absences (more than 5 days).
14.3 Boost function
Important: Boost mode can be activated at any time, regardless
of the operating mode used (Auto, Comfort, Eco or Frost
Protection).
To activate Boost mode, press
In the first minute, it is possible to change the Boost duration
from 0 to the maximum duration of the function by pressing
and .
This change will be saved and executed at the next Boost.
The desired temperature is set to the maximum for the required
time period.
• First pressure: Boost
Notes: After 1 minute, it is possible to temporarily change
the duration: it is valid only for the active Boost, therefore not
recurring.
If the ambient temperature reaches the maximum Boost
temperature, the device switches off but the Boost mode
remains active. The remaining time remains displayed, the
Boost symbol and the heating indicator flash on the display.
When the temperature falls below the maximum permitted
value, the Boost mode restarts until the remaining time is over.
To deactivate Boost mode, press
The cursor moves to the previous active mode and the set
temperature is displayed.
14.4 Comfort temperature setting
The Comfort temperature can be set from automatic and
Comfort modes. The default temperature is 19°C. Use the
and keys to adjust the temperature from 7°C to 30°C in
0.5°C intervals in case of heating with ambient temperature
setpoint.
.
again.
Code 1910000000356 - nv02