Cordivari Tessuto Electric EL.3X1800 Manual De Uso página 25

placed on a table using the table stand.
• Wall installation:
a) Unscrew the 2 screws under the thermostat and remove
the wall support.
b) Fasten the panel to the wall with the two screws supplied,
using the horizontal and vertical holes
• Table stand
a) Insert the 2 pins into the wall panel
b) Slide the support to the right
• Installation of batteries
a) Remove the battery compartment cover on the front of the
thermostat
b) Insert the 2 AA batteries supplied. When inserting batteries, take
care that the polarity is correct, according to the indication on the thermostat
c) Reposition the battery compartment cover
10. RF receiver/remote
connection
Code 1910000000358 - nv02
The RF remote control and RF receiver are not connected as standard.
A maximum of 5 RF receivers can be connected to each RF
remote control, i.e. five different products which, however, will
work in the same mode and with the same settings.
• RF connection
a) Switch on the receiver by pressing the key
b) Activate the connection mode on the receiver
by pressing the memo key for 5 sec.
The LED indicator on the receiver will start flashing in RED
c) Activate the connection mode on the remote control by
activating the frost protection mode by pressing the mode key 3
times and then OK for 5 sec.
d) When the remote control and RF receiver are connected,
the symbol
e) To cancel the connection, press the memo key for more
than 10 seconds on the RF receiver
Table showing the connection status between remote control
and receiver
RF communication status
Stand-by
No RF connection
RF connection
RF connection cancellation
RF connection OK
RF message received
Table indicating the operating mode
RF communication status
Stand-by
Switching on
Heating on
Boost
Frost protection, open
window detection
Manual activation (MEMO
button)
control
11. Using the Receiver without remote
control
- 25 -
5 sec
is steady on
LED status and colour
Off
Red
Flashing red
Quick flashing red
Green
Green - quick flashing for 1 sec.
LED status and colour
Off
Green
Red
Flashing red
Flashing green
Flashing orange
English