Publicidad
Idiomas disponibles
Idiomas disponibles
English
•
Frost protection mode
This mode allows you to protect your home against the effects
of cold (frozen pipes, etc.) while maintaining a minimum
temperature of 7°C at all times with ambient temperature
setpoint, 10.0°C with surface temperature setpoint. Select this
mode for long absences (more than 5 days).
14.3 Boost function
Important: Boost mode can be activated at any time, regardless
of the operating mode used (Auto, Comfort, Eco or Frost
Protection).
To activate Boost mode, press
In the first minute, it is possible to change the Boost duration
from 0 to the maximum duration of the function by pressing
and
.
This change will be saved and executed at the next Boost.
The desired temperature is set to the maximum for the required
time period.
•
First pressure: Boost
Notes: After 1 minute, it is possible to temporarily change
the duration: it is valid only for the active Boost, therefore not
recurring.
If the ambient temperature reaches the maximum Boost
temperature, the device switches off but the Boost mode
remains active. The remaining time remains displayed, the
Boost symbol and the heating indicator flash on the display.
When the temperature falls below the maximum permitted
value, the Boost mode restarts until the remaining time is over.
To deactivate Boost mode, press
The cursor moves to the previous active mode and the set
temperature is displayed.
14.4 Comfort temperature setting
The Comfort temperature can be set from automatic and
Comfort modes. The default temperature is 19°C. Use the
and
keys to adjust the temperature from 7°C to 30°C in
0.5°C intervals in case of heating with ambient temperature
setpoint.
.
again.
- 28 -
From 20°C to 80°C, in 5°C intervals, in case of heating with
surface temperature setpoint.
14.5 Displaying measured surface temperature
From Auto mode:
Press
Ambient
temperature
control
Press
or
to select the radiator (in case several devices
are connected to the RF control)
Press
or
to return to Auto mode
14.6 Displaying ambient temperature limitation
From Auto mode:
Press
Press
or
to return to Auto mode
Superficial
temperature
control
Code 1910000000358 - nv02
Publicidad
