Publicidad
Idiomas disponibles
Idiomas disponibles
2.6 Fitting The Machine Undercounter
If you wish to fit your machine
undercounter, there must be sufficient
space to do so and the wiring-plumbing
must be suitable to do so (1). If the space
under the countertop is suitable for fitting
your machine, remove the worktop as
shown in the illustration (2).
WARNING: The countertop, which
the machine will be placed under, must be
stable in order to prevent imbalance.
The top panel of the dishwasher must
be removed to fit the machine under the
countertop.
To remove the top panel, remove the
screws that hold it on, located at the rear
of the machine. Then, push the panel 1 cm
from the front towards the rear and lift it.
Adjust the machine feet according to the
slope of the floor (3).
Fit your machine by pushing it under the
counter taking care not to crush or bend the
hoses (4).
WARNING: After removing the top
panel of your dishwasher, the machine
should be placed in a space of the
dimensions shown in the figure below.
H1: min A
H2: min B1
H3: min B2
Product's Height
(±2 mm)
A: If there is no felt on the top of the
product; you should take into account this
product's height.
B1: If there is felt on the top of the product
with 2nd basket; you should take into
account this product's height.
B2: If there is felt on the top of the product
with 3rd basket; you should take into
account this product's height.
EN - 11
A
B
All
B
Products
1
820 mm
825 mm
B
2
835 mm
Publicidad
