Publicidad
Idiomas disponibles
Idiomas disponibles
• Perform the mounting carefully by one ot two adults!
• For preventing injuries, protective gloves are recommended.
• Ensure enough free space around the device for mounting and for use!
• Firmly tighten all component parts and pre-assembled parts!
• After assembly, perform a thorough visual inspection as described in
the subsection of the safety instructions.
Scan the QR code on page 18 and look up our installation video on YouTube.
Steps 1:
Unpack all parts and lay them out clearly on a free area.
Step 2:
Perform only with 10-ft-vatiant of trampoline:
With the 8-ft-variant, jump directly to step 3. (The feet will not be pronlongued here.)
Take a stand (#A1) and attach it to either side with one on each stand extension (#A2) together. Repeat this substep a
total of three times. Turn one screw (M6 * 10) on both sides of the stand (#A1) using a curved washer clockwise into the
opening provided and tighten this.
Repeat this step a total of three times. Put the three extended feet aside for now.
Figure 1
Steps 3:
Now lay out the 6 frame pieces (#A3) in front
of you. Make sure that the brackets of the feet
(#A1) point downwards and the narrow ends of
the frame pieces meet the wide ones (Fig.3).
Put the laid out frame pieces (#A3) together,
by inserting these narrow ends into the wide
ones and then with 6 screws (M6 * 10). Using
curved washers in the openings provided fix in
a clockwise direction (Fig.4).
Note: If the last piece turns out to be stiff, please
ask the second person with you to lightly push
the frame in on the diagonally opposite side
and you push from your direction as you join
the Frame Pieces (#A3) together.
6. MOUNTING / ASSEMBLY
Figure 3
Figure 4
26
Figure 2
Publicidad
