Publicidad
Idiomas disponibles
Idiomas disponibles
Step 13:
Now place the edge cover (#E) on the edge of the
jumping mat (#C) so that the basic structure
and the metal springs (#D2) are covered. The seams
of the edge cover should be at the same level as the
protective net holder (Fig. 20).
IMPORTANT: Make sure that the safety instructions
on the edge cover are at the entrance and exit of
the protective net (Fig. 21). These must be read and
understood before each use. To increase security, the
edge cover can also be attached to the frame struc-
Figure 21
Figure 20
ture with additional loops, which are located on the
underside of the cover.
Step 14:
Open the zip of the entrance and exit on the pro-
Figure 22
tective net (#D1) and slide this first on the edge of
the jumping mat (#C). Now step onto the jumping
mat and begin to pull the six fiberglass rods (#D3)
through the nylon edges provided at the upper end
of the protective net. Make sure you lay out the
poles in the same direction. Now put them together
by guiding the fiberglass rods through the caps at-
tached in step 6 above the protective net holder
and using the metal connecting pieces attached to
the fiberglass rods (Fig. 22), which should be at the
same level as the protective net holders (Fig. 23).
Figure 23
Note: If this proves to be difficult, pull the protec-
tive net holder with a little force in the direction of
the jumping mat, in order to be able to push the
fiberglass rods better through the openings and
connect them. We recommend doing this step with
a second person.
30
Publicidad
